Wosport Large HPA / Gas Cylinder Case — Ranger Green

Cordura case designed to protect HPA cylinders and gas cartridges up to 120 x 150 mm during transport and field use. The port at the base allows the regulator fitting to pass through and remain accessible without removing the case — a practical detail for those running HPA systems connected directly to the replica.

The Cordura fabric absorbs and dissipates solar heat, reducing the risk of pressurised cylinders overheating under direct sunlight. The base is sealed by a bidirectional YKK zipper with a water-resistant treatment that keeps dust and moisture out of the compartment: useful in field conditions, but not to be mistaken for a certified waterproof seal. A zip-closed panel on the front is sized to hold an identification patch.

Retention relies on the YKK base zipper rather than a quick-release fastener on the body: the case provides solid passive protection for its contents but is not designed for rapid extraction on the move. The side handles allow the case to be attached to a pack or belt via strap or carabiner, with no integrated MOLLE/PALS system — mounting flexibility is high, but placement on the body depends on the gear available.

Key points

• Base port for the HPA fitting: the regulator stays reachable without pulling off the case
• Cordura with thermal properties that limit cylinder heating under direct solar radiation
• Bidirectional YKK zipper with water-resistant treatment to keep out dust and moisture
• Front zip panel for an identification patch or quick content recognition
• Bilateral handles for attachment to packs, belts or harnesses via strap or carabiner

In the box

• Wosport Large HPA / Gas case in Ranger Green